alfer® aluminium

Parquet and laminate profiles

clipstech® level compensator profiles, 40 mm and 56 mm

The 40 mm wide alfer® clipstech® level compensator profiles of anodized or powder-coated aluminium bridge expansion joints between two different-height floor coverings permanently. Due to the different length shanks they compensate for height differences up to 17.0 mm. For floor covering height ranges see Table CL 03.
The 56 mm wide alfer® clipstech® level compensator profiles compensate height differences of up to 22.0 mm due to their different length shanks. For floor covering height ranges see Table CL 04.
With both clipstech® level compensator profiles rough edges are covered, necessary expansion joints are maintained. Easy clip-on mounting.

Table CL 03: clipstech® level compensator profiles, 40 mm


Level differences from 6.0 mm up to zu 17.0 mm be compensated. 2.0 mm impact noise insulation (green) was taken into consideration for the bend-up technology.
	Bend-up technology	Pivoting wing technology for coverings of different heights

Color Support profile white ivory gray caramel brown

from dim. a 4.5 mm 7.0 mm 9.5 mm 12.0 mm 19.0 mm

to dim. b 6.5 mm 9.0 mm 11.5 mm 15.0 mm 22.0 mm

dim. c 0.0 mm 2.5 mm 5.0 mm 7.5 mm 14.5 mm

from dim. a –6.5 mm –4.0 mm –1.5 mm 1.0 mm 8.0 mm

to dim. b 10.5 mm 13.0 mm 15.5 mm 18.0 mm 25.0 mm

Table CL 04: clipstech® level compensator profiles, 56 mm

Level differences from 9.0 mm up to 22.0 mm can be compensated. 2.0 mm impact noise insulation (green) was taken into consideration for both technologies.

	Bend-up technology	Pivoting wing technology for coverings of different heights

Color Support profile white ivory gray caramel brown

from dim. a 5.0 mm 8.0 mm 11.0 mm 14.0 mm 19.5 mm

to dim. b 7.5 mm 10.5 mm 13.5 mm 16.5 mm 23.5 mm

dim. c –2.0 mm 0.0 mm 2.5 mm 5.0 mm 12.0 mm

from dim. a –10.0 mm –7.5 mm –4.5 mm –2.5 mm 4.0 mm

to dim. b 12.0 mm 14.5 mm 17.0 mm 19.5 mm 16.5 mm

User tips

Mounting the clipstech®-plus decor profiles is quite simple. The decor profile is placed on the support profile so that the joint pan and head are opposite. Use a hammer and a padded wood block to firmly tap the decor profile onto the support profile.

Download our current product information
from the Download area as PDF files.

Important note: Please understand that we only supply to DIY stores and
specialist retailers. Only our model construction range is available
from our e-shop at www.alfer-shop.com.